@article { author = {Edalat, Ali and Siahkoohi, Hamid Reza and Tavakoli Moghaddam, Reza}, title = {Effective porosity estimation using multiattribute analysis}, journal = {Iranian Journal of Geophysics}, volume = {3}, number = {1}, pages = {1-18}, year = {2008}, publisher = {Iranian Geophysical Society}, issn = {2008-0336}, eissn = {2783-168X}, doi = {}, abstract = {In this study, an attempt is made to predict effective porosity in one of the oil fields in the Persian Gulf by designing a probablistic neural network (PNN) and simultanusely making use of seismic attributes and effective porosity logs in the reservoir window. This was done by deriving a multiattribute transformation between an optimum subset of seismic attributes and the effective porosity logs. The geophysical data used in this study consist of 3D seismic pre-stack time migrated (PSTM) data with 12.5*12.5 m grid size and a 4 ms sampling rate. The length of the seismic traces are two seconds. Well logs of five vertical wells in the study area, including Sonic (DT), Density (RHOB), Effective Porosity (PHIE) and Seismic Well Velocity Surveys (Check Shots), were used. The reservoir layer is a Mishrif member of the Sarvak formation with Cretaceous age, which is common in oil reservoirs in the Persian Gulf. The top of the Mishrif is adjusted with the Middle Turonian Unconformity and covered with shaley Laffan formation. The Mishrif Reservoir in study area contains two reservoir zones. The lower zone with higher clay content is separate from the upper zone. The upper zone consists of clean limesone with better reservoir properties. Seismic traces close to the well locations were used to generate seismic attributes. Effective porosity logs at the reservoir area were the target logs in this study. The designed neural network consists of one input layer, one hidden layer with four processing units (neuron), and one output layer with one neuron. In order to prepare training samples for the neural network, PHIE logs were converted to time domain using a time-depth relationship calculated from the DT logs and check shot curves for each well location. Subsequently, these logs were filtered (using a Hanning filter with 4 ms length) and resampled with  seismic sampling rate (4 ms). Finally, a set of seismic attributes, including sixteen sample-based seismic attributes, were generated using HRS software. Training samples in this study consisted of 57 samples (selected seismic attributes and their related effective porosity from PHIE logs in the time domain). For training the network, the samples were divided into three data sets: the training samples, cross validation samples and testing samples. The training data were used for adjusting the weights of the network; the cross validation data were used to prevent overtraining the neural network; and the testing data were used to ensure generalizabillity of the network output. A forward stepwise regression process was used to determine an optimum subset of attributes for use in the training of the neural networks. The optimum subset of attributes in this study consists of the Dominant Frequency, Amplitude Weighted Frequency, Integrated Absolute Amplitude and Filter 45-60 Hz. After the network was trained using training and cross validation data sets, it was used to predict the testing data. The results show a good correlation between real and predicted data, with 92% correlation. Finally, in order to attain a better generalization of the network, testing data sets were inserted to trained data and the network was trained again. This network was then used to predict effective porosity in well locations which increased the correlation coefficient to 95%. This study shows the ability of the PNN networks to predict effective porosity even with a paucity of training examplares.  }, keywords = {Neural Network,seismic multiattributes,Reservoir characterization,Effective porosity}, title_fa = {برآوردکردن تخلخل مؤثر مخزن با استفاده از تحلیل چند‌نشانگری}, abstract_fa = {در این تحقیق با طراحی کردن یک شبکه عصبی احتمالاتی و همچنین استفاده همزمان از نشانگرهای لرزه‌ای و نگاره‌های تخلخل مؤثر چاه‌ها در محدوده مخزن، سعی در برآورد کردن تخلخل مؤثر در یکی از میادین نفتی واقع در خلیج فارس نموده‌ایم. برای رسیدن به این هدف از تبدیل چند‌نشانگری بین زیر مجموعه‌ای بهینه از نشانگرهای لرزه‌ای و نگاره‌‌های تخلخل مؤثر استفاده شده است.داده‌های لرزه‌ای استفاده شده در این تحقیق شامل مکعب داده‌های لرزه‌ای سه‌بعدی مهاجرت‌ یافته قبل از برانبارش (PSTM) می‌باشد که دارای اندازه بلوک 5/12 x 5/12 متر می‌باشد که فاصله نمونه برداری زمانی این داده‌ها چهار میلی ثانیه و طول تریس‌های لرزه‌ای دو ثانیه است. همچنین از اطلاعات پنج چاه قائم که در منطقه مورد مطالعه حفر شده‌اند و دارای مجموعه کاملی از نگاره‌های صوتی (DT)، چگالی (RHOB)، تخلخل موثر (PHIE) و داده‌های سرعت چک شات (Check shots) هستند نیز استفاده شده است. لایه مخزنی مورد مطالعه، بخش میشریف از سازند سروک با سن کرتاسه میانی می‌باشد که یکی از مخازن نفتی مهم در خلیج فارس است. راس میشریف منطبق است با سطح ناپیوستگی ترونین میانی (Middle Turonian Unconformity) و توسط سازند شیلی لافان پوشیده شده است. بخش میشریف در منطقه مورد بررسی از دو زون مخزنی تشکیل شده است. زون پائینی با دارا بودن محتوای رسی بیشتر از زون بالایی متمایز می‌گردد. زون بالایی شامل سنگ آهک‌های تمیز با خصوصیات مخزنی مناسب‌تری است.برای تولید نشانگرهای لرزه‌ای مورد نیاز، ردلرزه‌ای موجود در محل چاه‌ها از مکعب داده‌های لرزه‌ای سه‌ بعدی استخراج شدند. در این تحقیق نگاره‌های تخلخل مؤثر در محدوده مخزن، حکم نگاره‌های هدف را داشتند.شبکه عصبی طراحی شده شامل یک لایه ورودی، یک لایه مخفی با چهار واحد پردازشی (نرون) و یک لایه خروجی می‌باشد. به‌منظور تهیه نمونه‌های آموزشی برای آموزش شبکه عصبی، ابتدا نگاره‌های PHIE با استفاده از رابطه زمان – عمق که با استفاده از منحنی‌های چک‌شات و نگاره‌های DT در محل هر کدام از چاه‌ها محاسبه شده بودند، به حوزه زمان برگردانده شدند. سپس این نگاره‌ها با استفاده از فیلتر هنینگ با طول 4 میلی ثانیه فیلتر شده و با نرخ نمونه‌برداری اطلاعات لرزه‌نگاری (4 میلی‌ثانیه) نمونه‌برداری مجدد شدند. در مرحله بعد یک مجموعه از نشانگرهای لرزه‌ای شامل شانزده نشانگر لرزه‌ای بر پایه نمونه تولید شد. نمونه‌های تهیه شده در این مطالعه (نشانگرهای لرزه‌ای انتخاب شده به همراه داده‌های تخلخل مؤثر متناظر در حوزه زمان) شامل 57 نمونه می‌باشد. برای آموزش شبکه، نمونه‌ها به سه بخش نمونه‌های آموزشی، اعتبار سنجی متقابل و آزمایشی تقسیم شدند. از نمونه‌های آموزشی برای تنظیم وزن‌ها، از نمونه‌های اعتبارسنجی برای پیشگیری از آموزش اضافی شبکه و از نمونه‌های آزمایشی، برای اطمینان از قابلیت تعمیم شبکه استفاده شد.به‌منظور انتخاب بهترین نشانگرها برای آموزش شبکه عصبی، از روش برازش گام به گام پیشرو استفاده شده است. چهار نشانگر فرکانس غالب، دامنه تجمعی مطلق، فرکانس وزن‌دار دامنه و فیلتر میان‌گذر 60-45 هرتز تریس لرزه‌ای به‌عنوان بهترین نشانگرها انتخاب شدند.پس از آموزش شبکه، از این شبکه برای تخمین داده‌های آزمایشی استفاده شد. نتایج بدست آمده حاکی از همبستگی خوب بین داده‌های واقعی و داده‌های تخمینی به میزان 92% است. در نهایت به منظور بالا بردن قابلیت تعمیم شبکه، نمونه‌های آزمایشی به نمونه‌های آموزشی اضافه شد و شبکه مجدداً با تمامی داده‌ها آموزش داده شد و از آن برای تخمین تخلخل مؤثر در محل چاه‌ها استفاده شد. در این حالت ضریب هم‌خوانی بین داده‌های واقعی و داده‌های تخمینی به 95% افزایش یافت.  نتایج این تحقیق قابلیت بالای شبکه‌های عصبی احتمالاتی را در برآوردکردن تخلخل مؤثر، حتی در مواقعی که تعداد نمونه‌های آموزشی کم است، روشن ساخت.}, keywords_fa = {شبکه عصبی,چند‌نشانگرهای لرزه‌ای,توصیف مخزن,تخلخل مؤثر}, url = {https://www.ijgeophysics.ir/article_40851.html}, eprint = {https://www.ijgeophysics.ir/article_40851_9a468bd6dc07d9dc2e19d5102e32f180.pdf} }