آییننامه طراحی ساختمانها در برابر زلزله- استاندارد 2800 ویرایش سوم، 1384، کمیته دائمی بازنگری آییننامه طراحی مدلها در برابر زلزله، مرکز تحقیقات راه و مسکن.
مبحث ششم مقررات ملی ساختمان، بارهای وارد بر ساختمان، 1385، دفتر تدوین و ترویج مقررات ملی، وزارت مسکن و شهرسازی، ایران.
ASCE/SEI 7-05., 2006. American Society of Civil Engineering, Minimum Design Loads for Buildings and Other Structures.
AISC, 2005, Specification for Structural Steel Buildings, ANSI/AISC 360-05, March 9, American Institute of Steel Construction, Inc. Chicago, IL.
Chopra, A. K., Goel, P. K., 2001, A modal pushover analysis procedure to estimate seismic demands for buildings, Theory and Preliminary Evaluation, Berkeley Pacific Earthquake Engineering Research Center (PEER), University of California, Berkeley.
Chopra, A. K., and Chintanapakdee, C., 2004, Inelastic deformation ratios for design and evaluation of structures: single-degree-of-freedom bilinear systems: Journal of Structural Engineering, 130(9), 1309-1319.
Earthquake Engineering Software Solutions, Seismosoft, Products Seismostruct.
FEMA 440, 2005, Draft Camera-Ready for the Improvement of nonlinear static seismic Analysis procedures, prepared by the Applied Technology Council (ATC-55 project) for the Federal Emergency Management Agency, Washington, D.C.
Federal Emergency Management Agency (FEMA), 2000, Prestandard and Commentary for the Rehabilitation of Building, FEMA-356.
Fujimoto, M., Aoyagi, T., Ukai, K., Wada, A., and Saito, K., 1972, Structural Characteristics of Eccentric Braced Frames. Trans., 195, 39-49, AIJ, May. (in Japanese).
Gupta, b., 1999, Enhanced Pushover Procedure and Inelastic Demand Estimation for Performance-based Seismic Evaluation of Buildings, Ph. D. Dissertation, University of Central Florida, Orlando, FL.
Hjelmstad, K. D., and Popov, E. P., 1983, Cyclic Behavior and Design of Link Beams: Journal of Structural Engineering, 109(10), 2387-2403, October, ASCE, Reston, VA.
Krawinkler, H., Seneviratna, G. D. P. K., 1998, Pros and Cons of a pushover analysis of seismic performance evaluation: Engineering Structures, 20(4), 452-464.
International Building Code, 2006, IBC2000.
Kasai, K. and Popov, E.P., 1986, General Behavior of WF Steel Shear Link Beams” Journal of Structural Engineering, ASCE, 112(2), Reston, VA.
Kasai, K. and Popov, E. P., 1986, A Study of Seismically Resistant Eccentrically Braced Frames, Report No. UBC/EERC-86/01, Earthquake Engineering Research Center, Berkeley, CA.
Krawinkler, H., 1995, New trends in seismic design methodology: Proceedings 10th European Conference on Earthquake Engineering, Vienna, Austria, Rotterdam: AA Balkema, 2, 821-831
Mwafy, A., and Elnashai, A., 2001, Static pushover versus dynamic collapse analysis of RC buildings: Engineering Structures, 23(5), 407-424.
Popov, E., and Roeder, C., 1978, Eccentrically Braced Steel Frame for earthquakes: Journal of the Structural Division, 104(3), 391-412.
SAP2000, Nonlinear Analysis Reference Manual, Version 14, 2008, Computers & Structures, INC. Berkeley, California. Earthquake Spectra, 5(3): Earthquake Engineering Research Institute, Oakland, CA.
UBC-IBC Structure, 1997-2000, Structural Comparison and Cross References.
Wilson, E. L., Farhoomand, I., and Bath, K. J., 1972, Nonlinear dynamics analysis of Complex Structures: International Journal of Earthquake Engineering and Structural Dynamics, 1, 241-252.